By 3 min read

How do I add a gateway in Cucm?

Activity Procedure

  1. On Cisco Unified Communications Manager Administration page, from the menu select Device > Gateway and click Add New.
  2. For gateway type, select H.
  3. On the Gateway Configuration page, use the following parameters:
  4. Click Save.
  5. Click Reset button, and another Reset button.

How do I change my Cucm gateway?

Change the IP Address in CUCM Admin Page

  1. Login to CUCM Publisher Admin Page GUI >
  2. Go to System > Server > Click on the IP Address for which you want to change into a New IP Address.
  3. Host Name/IP Address > Enter the IP Address of the Publisher/Subscriber and click on Save.

What is an H 323 gateway?

An H. 323 gateway is an optional type of endpoint that provides interoperability between H. 323 endpoints and endpoints located on a Switched Circuit Network (SCN), such as the public switched telephone network (PSTN) or an enterprise voice network.

What is an H 323 device?

H. 323 provides standards for equipment, computers and services for multimedia communication across packet based networks and specifies transmission protocols for real-time video, audio and data details. H. 323 is widely used in IP based videoconferencing, Voice over Internet Protocol (VoIP) and Internet telephony.

What is Cucm gateway?

PSTN phone numbers are configured as Route Patterns in CUCM. These phone calls are normally routed out a gateway for PSTN access. A gateway serves a very special purpose in Unified Communications. The Cisco gateway router converts the VoIP RTP (Real Time Protocol) to a TDM (Time Division Multiplexing) format.

What is a voice gateway router?

A voice gateway is one of the most important components within a voice over IP infrastructure. The voice gateway is used to connect the enterprise VoIP network with the telecommunications provider, using a number of different connectivity methods, such as PSTN, ISDN and SIP.

How do I find my CUCM IP address?

there are two ways to verify the IP settings on your CUCM servers, 1.)…Using The CLI

  1. Set network dns primary x.x.x.x.
  2. Set network dns secondary x.x.x.x.
  3. set network [ip|ipv6] addr x.x.x.x mask x.x.x.x gw x.x.x.x.