How do I reset my HP POE switch?

To execute the factory default reset on the switch, perform these steps:

  1. Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.
  2. Continue to press the Clear button while releasing the Reset button.
  3. When the Self Test LED begins to blink, release the Clear button.

How do I put HP switch into configuration mode?

Configuration commands and the context configuration modes

  1. HP Switch(config)# interface c3-c6. HP Switch(eth-C5-C8)#
  2. HP Switch(eth-C5-C8)# HP Switch(eth-Trk1)#
  3. HP Switch(config)# vlan 100. Command executed at configuration level to enter VLAN 100 context.
  4. HP Switch(vlan-100)#
  5. HP Switch(vlan-100)#?

How do you set the default gateway on a HP switch?

Menu: configuring IP address, Gateway, and Time-To-Live (TTL)

  1. From the Main Menu, select:
  2. Press [E] (for Edit).
  3. If the switch needs to access a router, for example, to reach off-subnet destinations, select the Default Gateway field and enter the IP address of the gateway router.

How do I restore my HP 1920 to factory settings?

Restoring to factory defaults

  1. Using a small, thin tool with blunt ends (such as a paper clip), press the Reset button on the front of the switch.
  2. Continue to press the Reset button until the Fault LED light begins to flash.
  3. Release the Reset button.

What is the default password for HP switches?

The default username for first time configuration is admin, no password is required.

What is the default admin password for HP printers?

Open a web browser and type the printer IP address in the address field exactly as it appears on the Configuration Page, and then press Enter. Click the Security tab, and under General Security, set the local administrator password. Keep the username default as admin. Type the New Password and Verify Password.