How do I reset my Trane xl80 furnace?

If you look inside the blower motor fan, you should find the reset button. Look for a small red or yellow button on the side of the blower motor. If you do not see one on the side of the motor that is facing you, feel around to the back of the motor housing for the button.

What does a red flash code indicate?

1 RED FLASH: This indicates that flame was sensed when there was not a call for heat. With this fault code the control will turn on both the inducer motor and supply air blower. A gas valve that leaks through or is slow closing would typically cause this fault.

Is there a reset button on a Trane furnace?

To access it, you’ll need to remove the front panel of the furnace. You may find that many models have limit switches where the reset button is located. The button is often located on top of the switch and will need to be pressed to initiate the reset.

Where is the reset button on a Trane xr95 furnace?

All models are equipped with a manual resetting roll- out switch located near the burners. In case of flame roll-out, the switch trips automatically shutting off all flow of gas. The switch must be manually reset by pressing the red reset button on the top of the switch.

How do I reset my Trane?

All Thermostat Models

  1. MAKE SURE THAT THE HVAC SYSTEM IS IDLE BEFORE PROCEEDING!
  2. Locate the switch for your thermostat in the breaker box.
  3. Flip the switch to the OFF position for 20-30 seconds.
  4. Return the switch to the ON position.
  5. The reboot process will take several minutes to complete.

What does a red blinking light on a Trane furnace mean?

The red blinking light for your Trane XR90 furnace indicates that your unit was shut off due to a problem. Your system is currently locked out of its normal operation or ability to function.

Why is there a red light flashing on my furnace?

This could be an indicator your flame sensor is dirty, and cleaning it should fix it. However, this could also mean there is a problem with the gas valve or ignitors. Gas can be intimidating to mess with, so it’s best to call Doc Dancer.

How do you reset a Trane?

Where is furnace reset button?

Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.

When should a furnace be reset?

If your furnace doesn’t have any air coming out at all and the pilot light is out, it’s worth it to try resetting the furnace. If this doesn’t work, there may be a problem with the thermostat setting, the power, or the gas line.

What does a blinking red light mean on a Trane furnace?