How do I reset my uverse remote control?
How to reset U-verse TV remote controls
- Press and hold the AT and the OK key simultaneously.
- Release both keys and all four mode keys will flash twice to indicate you are in programming mode.
- Enter programming code 900 by pressing the number keys on the remote control.
How do I fix my AT uverse remote?
Restart your receiver – Hold down the POWER button for 10 seconds then press it again to restart. This process will take 5-8 minutes and will impact any DVR recordings in progress. Order a replacement remote – visit the online Accessory store to order a replacement U-verse TV remote control.
Why is my remote control not working properly?
Make sure none of the remote buttons are jammed. Reset the remote. The remote may not work temporarily due to poor contact of the battery or static electricity. Remove the batteries from the remote (for approximately 1 minute).
Why does my TV remote not work sometimes?
Clean the remote control terminals. The remote control battery terminals may be dirty. Remove the batteries and clean the remote control terminals with a small solution of alcohol, using a cotton bud or soft cloth, then place the batteries back into the remote control. Replace with fresh batteries.
How do I get my AT remote to work?
Here’s all you need to do:
- With your TV on, use your U-verse TV remote and press Menu.
- Select Help > Information > Remote Control Setup.
- Next, select your remote control from the TV onscreen list. Refer to your specific remote for TV/device setup options.
- Select Top Ten Brand Setup, Automatic Code, or Manual Setup.
Why is my AT TV remote flashing blue?
Refreshing the connection between your remote and DIRECTV STREAM device can fix many common problems. Here’s how: First, unpair your remote from the device: Press and hold DASH (–) and APPS or Diamond buttons until you see the LED lights on the remote blink blue twice.
Why does my AT remote keep flashing?
Replace the batteries – Red Blinking Light Over time, batteries lose their charge and a message to change the batteries normally appears and the light will blink red. Low-level battery life may cause sluggish remote commands and prevent you from using Google Assistant.
How do I program my uverse s10 remote?
Press and hold the mode button you want to assign to the equipment (TV, DVD, or AUX) along with the Enter button. Hold both buttons for one second, and then release. The four mode buttons on the remote control will flash twice to indicate you’re in programming mode.
Why is my ATT TV remote volume not working?
Make sure the mute button hasn’t been pressed or the volume turned down on your TV, U-verse remote control, or other connected audio equipment. If you are using a home theatre system, check to see that the power is on and the correct output is selected. Make sure the volume is not muted and is turned up on that system.